Brey Krause Harness Mount Hardware

For mounting lower center harness strap on 5 & 6 point harnesses. For 911, 964 & 993 Models from 1974-98. Attaches to floor pan using factory seat mounting points

For GT3 & Race Seats fitted in 996 / 997 Boxster & Cayman models. For mounting lower center harness strap on 5 & 6 point harnesses using a one-piece seat with anti-sub strap pass-through. This mount works in conjunction with factory & EuroCupGT 996/997/Boxster Manual slider kit and with the BK R-2030 fire extinguisher mount.

In response to the many requests from Porsche drivers looking for a harness guide bar that would not only guide their driving harnesses but also allow them to mount their harnesses directly to the bar, BK developed the "Harness Truss".for Motor Vehicle Seat Belt Anchorages-Performance Requirements. It's strong, yet it weighs only a fraction of what a support of the same strength made from tubular or bar steel would weigh. The Harness Truss is precision water-jet machined for a perfect fit into Porsche factory mounting points. This type of machining is accurate and does not create heat affected areas in the metal which can alter tensile strength. Strength requirements for harness mounts are considerably greater than those for harness guide bars since they must support the entire load applied to the belts. Material: 6061-T6 aluminum skeleton and reinforcing bar. Type 304 stainless steel brackets. Finish: Anodized aluminum with satin stainless mounting brackets. Models: 911 Coupes '74 - '98 Installation: Bar attaches to factory mounting points in "B" pillars. Harness Truss is designed to allow enough seat travel for tall drivers. The stainless steel mounting brackets can be left installed in the "B" pillars to easily remove and remount the bar in minutes.

Satin finish stainless steel. Porsche All 911, 924 944 968 928 964 993 996 997 Boxster & Cayman Models Secures snap-in Harness lap belts to outside seat belt mounting point. Allows user to remove and install belts in seconds. Will not interfere with factory seat belt. One pair will work for both seats.

Satin finish stainless steel. Porsche All 911, 924 944 968 928 964 993 996 997 Boxster & Cayman Models Secures snap-in Harness lap belts to outside seat belt mounting point. Allows user to remove and install belts in seconds. Will not interfere with factory seat belt. One pair will work for both seats.

Satin finish stainless steel. Porsche 911 924 944 968 964 993 Boxster Cayman & 996 / 997. Secures snap-in lap belts to factory tunnel side (inside) seat belt mounting point. Allows user to remove and install belts in seconds. Will not interfere with factory seat belt. One pair will work for both seats

Clear Anodized Aluminum, fits all models. Attaches to roll cage. Fits 1.5" roll cage also available for 1 5/8" roll cage, please specify diameter when ordering

This Hardware kit is required for installation of the Seat Belt mounts in 1974 - Onwards. All models